Special K - The Official Wiki

Installer

Details about the main Special K installer

The latest stable installer can always be found at this direct link. The installer is built using Inno Setup and uses its standard exit code.

Exit codes

0 - Installation successful

Setup was successfully run to completion or the /HELP or /? command line parameter was used.

10 - Installation successful but a restart is required

Setup was successfully run to completion but a restart was flagged as being required.

1 - Installation failed

Setup failed to initialize.

2 - Installation cancelled by user

The user clicked Cancel in the wizard before the actual installation started, or chose "No" on the opening "This will install..." message box.

3 - Disk space is full

A fatal error occurred while preparing to move to the next installation phase (for example, from displaying the pre-installation wizard pages to the actual installation process). This should never happen except under the most unusual of circumstances, such as running out of memory or Windows resources.

4 - Installation failed

A fatal error occurred during the actual installation process.

Note: Errors that cause an Abort-Retry-Ignore box to be displayed are not fatal errors. If the user chooses Abort at such a message box, exit code 5 will be returned.

5 - Installation cancelled by user

The user clicked Cancel during the actual installation process, or chose Abort at an Abort-Retry-Ignore box.

6 - Forcefully terminated

The Setup process was forcefully terminated by the debugger (Run | Terminate was used in the Compiler IDE).

7 - Installation failed

The Preparing to Install stage determined that Setup cannot proceed with installation. (First introduced in Inno Setup 5.4.1.)

8 - Restart required

The Preparing to Install stage determined that Setup cannot proceed with installation, and that the system needs to be restarted in order to correct the problem. (First introduced in Inno Setup 5.4.1.)